In addition to be careful in the using process of the diamond wire rope saw cutting, the maintenance of the diamond rope cutting for rock is also very important. Because the condition of your marble wire saw rope can affect the result of the using of the diamond wire saw. Have you learnt how to take care of the granite quarry diamond wire?

Here we have some tips for diamond wire saw’s maintenance.

1. You should check the cable conductor of the diamond wire for marble regularly and the damaged cable conductors must immediately bandage or replace to prevent leakage.

2. You should always check the driving flywheel and the guide wheel of the diamond wire saw stone cutting is normal or not, the broken should be replaced otherwise it will lead to abnormal wear of diamond wire

3. If the granite quarry diamond wire installed a special manual lubrication system, the operator must give each lubricating point equipment manual pump lubricating oil every day.

 4. You should check the radiator cover of the granite diamond rope saw is clear or not .The blocking of the diamond wire for marble must immediately clear so as not to affect the main motor cooling.

5. When you use the diamond cable wire saw in horizontal plane cutting operation, you should pay attention to the waterproof vents to prevent the main motor the cooling water through cooling into the mouth of the main motor to cause the short circuit of the granite diamond rope saw.

6. Keep regular cleaning of the electric control box; keep the diamond wire saw clean and the operation table of moisture and dust.

7. Keep the interior of the control box dry. If the marble diamond wire saw was left unused for a long time, you should be dry before reuse.

8. You should clean up the middle feed roller of the diamond wire saw rope and daub grease to prevent rust.

9. You should promptly clean up the dirt on diamond wire saw after using and clean the granite quarry diamond once a week to prevent dirt corrosion of equipment.

10. You should be carefully and not to pull cable crassly in the process of moving the operation platform. Operation platform of the diamond wire saw stone cutting should be placed far away from the rain.

11. The normal operation of the granite diamond rope saw should be in the temperature range of -15 DEG and 40 DEG, we recommended to use at 0 degrees and 35 degrees in the temperature range.

12. The overhauling time of the diamond wire saw should be one year.

13. Please refer to the implementation of the safety rules of the granite diamond rope saw.

When you use the diamond wire saw, you had better to do those for your diamond cable wire saw. As far as I’m concerned, those suggestions can make a great benefit for you.